I have seen tons of these online, and they are pretty expensive.
Yes, its that cheap!
you’re able to even sell it and earn money.
Image by Matthew Peech via Youtube
But for me, Ill be using it to upgrade my outdoor space.
Learn the full instructions through the video below.
The bottom cross board should be placed an inch and a half down from the legs.
It should be 1 and 3/8 inches away from the side edges and 1 inch from the top.
Secure them together using brad nails.
Step 2:
Measure 1 1/2 from the bottom and top edge, then draw a line.
Next, draw screw placements on the line.
Drill the 1-inch coated deck screws on the marks.
Your first panel is done.
Make two pieces of panel A.
Step 3:
Make panel B.
Lay everything out exactly what you did for panel A.
The side measurement will be the only thing different as it will measure 11/16 from the outside edge.
Mark half an inch up from the panel, draw a line, and make the screw placements.
Once done, attach the screws.
Make another panel B for a total of 2.
Make a 35-degree angle for the long x on both ends.
Assemble them on panel A and secure them using brad nails.
Repeat for the other panel A.
Assemble them on panel B and secure them using brad nails.
Repeat for the other panel B.
Step 6:
Assemble the planter.
Panel B will sit inside the lip of panel A.
Attach them with brad nails first then attach the screws into panel A.
Step 7:
Lay your planter upside down.
Place one bottom board in the middle, then the other two 4 inches from the center.
Screw them in place.
Step 8:
Cut all top trim at a 45-degree angle on both ends.
Attach them to the planter and screw them in place.
Step 9:
Sand everything down and paint them.
